News

Hot stamping machine technical support
Addtime：2011-6-7 Editer：Amy 　　
From：HC factory

Hot stamping machine technical support

A） Hot stamping machine structure:

　 1) Worktable. To install fixture and article, there are mainly 2 kinds of worktable, flat worktable and shuttle worktable hot foil stamping machine.

　　 2) Stamping system. Stamping head with hot plate inside, hot plate can stamp up and down.

　　 3) Foil feed system. Install hot foil and heat transfer film, it was controlled automatically.

　　 4) Control system. Ensure printing process automatically and stably. Control panel has 2 kinds of printing mode, single printing for sample test and automatic printing for mass production.



B) 　4 Print factors for hot stamping machine:


1) Hot plate. There are silicon rubber plate, copper plate and zinc plate. They are fixed to the hot plate by high temperature tape or high temperature glue.

2) Hot foil. It must be test before mass production according to the material of article.

3) Temperature and pressure.

4) Fixture. It must withstand greater pressure and high temperature.




C) 　Different type of hot foil stamping machine：

1) Plane hot stamp machine. It’s for plane product printing.

2) Cylinder hot stamping machine, it’s for cylinder and cone product.

3) Plane and cylinder hot stamp machine, it can print on both plane and cylinder product.




D）　4 factors to effect stamp print effect：

1) Pressure

2) Temperature

3) Hot foil

4) Hot stamp plate




E）How to fix stamp plate?

1) By high temperature tape: Cut a piece of high temperature tape, size is the same as stamp plate, stick it to the back of stamp plate, then put it on the worktable, heating the hot stamping machine to 100-200 degree, then start the machine printing, so heat plate push down on the stamp plate, after heat plate rise up, the stamp plate and heat plate already stick together closely.


2) by high temperature glue: Apply glue evenly all over both stamping plate side and stamping former plate side, wait for 10-15 minutes, then assemble the two sides and press for a minutes.

Hot stamp forme